Cnc Machinist Set-Up
Resume:
Kenneth Hartwig
Fresno, Ca
Work Experience:
Keiser Corporation 08/2023 – 03/2024
CNC Machinist
• Set-up and operate numerically-controlled machine to perform any combination of
• machining operations such as turning, milling, drilling, reaming, or threading metal
• workpieces to specifications
• Review set-up sheet and program to determine sequence of operations and dimensions
• of finished workpiece; chucks or bolts fixture to machine bed, using wrenches
• Position metal stock in chucks or fixtures according to set-up instruction (using rule,
• calipers, and micrometers) and secures workpiece in place by actuating chuck jaws,
• using clamps or bolts
• Assemble cutting tools in tool holders and position tools in turret or machine spindles
• according to directions (using machinists’ hand tools), or insert cutting tools in specified
• machine magazine
• Observe machine operations and verify accuracy of machined workpiece against
• blueprints or engineering drawings by measuring cuts with micro-meters, dial indicators,
• and gauges
• Maintain cleanliness and safety of work area, and comply with safety standards and
• regulations
Saf-T-Cab 04/2023 – 08/2023
• Will be able to run CNC software
• Lasers, mills, lathes, drill center, sawing center, press brake, plasma and gas torches at
• the burn table
Total Concepts 03/2018 – 09/2022
CNC Machinist
• Set up machines (calibration, cleaning etc.) to start a production cycle
• Operated on Haas, CNC Mill and Lathe machines
• Use Probe or Edge finder to touch off parts to locate X,Y,Z offsets, touch off tools
• manually using 1.2.3 block or probe
• Edit tolerances
• Control and adjust machine settings (e.g., speed)
• Load and unload raw material or parts to CNC machines
• Inspect parts with precision and measuring tools
• Fix issues that might occur during the shift
• Check output to spot any machine-related mistakes or defects
• Knowledge of all measurement tools (caliper, micrometer etc.)
• Able read blueprints
Handyman Service & Construction 02/2016 – 01/2018
General Laborer and Remodeler
• Hand tools/power tools
• Drywall repair
• Framing
• Plumbing
• Sink and faucet installation
PNM 04/2009 – 12/2015
CNC Operator
• Set up CNC machine
• Read calipers, micrometers and blueprints
• HAAS, MAZAK, etc. machines
• Operate tumbler machines
Kodiak Cartoners 04/2008 – 11/2008
• Mill Worker (Manual)
• Review drawings and instructions
• Take precise measurements
• Able to read blueprints
• Control input of materials and oversee quality and quantity of product Adco Manufacturing 12/2006 – 02/2008
HAAS CNC Machinist
• Set-up CNC machine tooling and coordinate loading machining programs
• Performed quality control on manufactured parts for flaws or imperfections
• Operated a drill press to cut precision hole locations GE Polymershapes 07/2005 – 10/2006
CNC Operator
• Hand router
• Packaging/pallet
• Drill press, mill, and lathe
• Running a CNC Mastercam
• Hand cleaning up parts deburr
Contact this candidate